See page 8 for more information about this button.ī. Press the wireless enable/disable button to enable the wireless radio. If a wireless connection does still not exist, make sure that the wireless radio has not been disabled. Reboot process takes approximately 30 seconds. PDA – Use the PDA stylus to push the reset button located on the back side of the PDA.
In most cases, the easiest way to re-establish a connection is to perform a cold boot of the ScreenLogic device:Ī. Make sure your wireless ScreenLogic device (PDA and/or Tablet) are connected to the ScreenLogic If ScreenLogic has been previously working without a problem, try the following steps to resolve the problem:ġ. If the Configuration program displays “Looking for controller,” for longer then 60 seconds when you start IntelliTouch ScreenLogic, this may indicate a communication problem somewhere in the system. Why does the Configuration program say “Looking for Controller”? Note: If you purchased a PDA, In-wall touch screen, or Tablet, a CD-ROM is also included that contains the ScreenLogic PC interface for your Windows XP computer. For Technical Support contact information, see page viii. Please consult your manufacturer documentation for other questions. Technical support for non-supported devices is not available. IntelliTouch ScreenLogic can only be used with the provided ScreenLogic PDA, Tablet, and in-wall Touch Screen devices. There must be some way to reboot the PA back to default settings (the 3 resets presses clearly do not work).Use the following information to resolve general ScreenLogic operation issues.īefore contacting Pentair Water Technical Support, please note that Technical Support personnel can only assist with relevant questions regarding IntelliTouch ScreenLogic hardware and software. I believe this is my issue and do not want to spend $400+ unnecessarily. Without knowing the PA’s ip there is no way to see it on the network.Īfter reading for hours on TFP I see a lot of issues with PA’s losing communication when the router is changed. I contact the previous owner and they said it worked fine before they moved out. They concluded the PA needs to be replaced. I called pentair support and they had me hit the reset button 3 times and nothing. When connecting using the PC app (as admin on windows 10) the white box is blank. When I open the screen logic iOS app and try to connect it shows: Searching for system controller. When I connected everything to my home network, all the lights worked (red light on PA on and Tx/Rx lights flashing on the wireless interface and also on the antenna). The previous owner left the screen logic protocol adaptor and wireless interface. My issue is with the Screen Logic system that does not work. I just bought a house with pentair controls.
0 kommentar(er)
